TY - JOUR
N2 - In technology of coal fines beneficiation in Poland mainly fines jigging processes are in use. In case of steam coal fines beneficiation it is till 80% of the whole amount of produced assortments, while in case of coking coal fines it is 100%. The necessary condition of not homogenous feed separation which is directed to beneficiation process in pulsating water stream is a sufficient liberation of particles. The stratification of particles in working bed causes that particles of certain size, density and shape gather in individual layers in working bed of jig. The introduction of sufficient amount of additional water determines appropriate liberation of particles group, which generates partition into concentrate and tailings. The paper presents the results of sampling of industrial jig used for the beneficiation of coal fines by three various settings of additional amount of water under sieve which is directed to jigging. These amounts were equal to 35, 50 and 70 [m3/h]. Collected samples of separation products were then sieved into narrow particle size fractions and divided into density fractions. In such narrow size-density fractions the coordinates of partition curves were calculated for tailings of hard coal fines, which were subsequently approximated by means of Weibull distribution function. The separation precision measured by separation density, probable error and imperfection were determined on the basis of obtained model separation curves. The evaluation of separation effects was performed for a wide particle size fraction: feed directed to jigging process and narrow particle size fractions. The analysis of separation results in size-density fractions allowed to determine the influence of particle size change on the value of probable error. The results of separation precision in size-density fractions were compared with effects of separation of wide particle fraction, i.e. feed directed to jigging process.
L1 - http://rhis.czasopisma.pan.pl/Content/106736/PDF/Archiwum-63-2-12-Surowiak.pdf
L2 - http://rhis.czasopisma.pan.pl/Content/106736
PY - 2018
IS - No 2
DO - 10.24425/122457
KW - jig
KW - particle size
KW - separation precision
KW - probable terror
KW - Weibull distribution function
A1 - Surowiak, Agnieszka
PB - Committee of Mining PAS
VL - vol. 63
DA - 2018.06.30
T1 - The Analysis of Coal Fines Separation Precision Exposed to Changeable Hydrodynamic Parameters of Jig Work
UR - http://rhis.czasopisma.pan.pl/dlibra/publication/edition/106736
T2 - Archives of Mining Sciences
ER -