@ARTICLE{Królczyk_Grzegorz_M._Experimental_2014, author={Królczyk, Grzegorz M. and Legutko, Stanisław}, number={No 4}, journal={Metrology and Measurement Systems}, pages={759-770}, howpublished={online}, year={2014}, publisher={Polish Academy of Sciences Committee on Metrology and Scientific Instrumentation}, abstract={The objective of the investigation was to identify surface roughness after turning with wedges of coated sintered carbide. The investigation included predicting the average surface roughness in the dry machining of Duplex Stainless Steel (DSS) and the determination of load curves together with roughness profiles for various cutting conditions. The load curves and roughness profiles for various cutting wedges and variable cutting parameters were compared. It has been shown that dry cutting leads to a decrease in friction for lubricated surfaces, providing a small initial contact area where the surface is contacted. The study has been performed within a production facility during the production of electric motor parts and deep-well pumps.}, type={Artykuły / Articles}, title={Experimental Analysis by Measurement of Surface Roughness Variations in Turning Process of Duplex Stainless Steel}, URL={http://rhis.czasopisma.pan.pl/Content/90294/PDF/Journal10178-VolumeXXI%20Issue4_13.pdf}, doi={10.2478/mms-2014-0060}, keywords={turning, coatings, friction-reducing, optical microscopy, surface roughness analysis and models}, }