Washing is very popular technological operation removing clay particles from aggregates. The amount of mineral washing sludges increases. Besides filling the excavations, there is no common method of their utilization. The usage of sludges from washing aggregates in building ceramics might be environmentally friendly way to utilize them. This paper presents laboratory research on two type of sludges: from dolomite and limestone aggregates washing. Selected properties of sludges such as water content, particle size distribution (sieve and areometric method), chemical composition (XRF), mineral composition (XRD), thermal properties (STA/EGA, dilatometry, heating microscopy) and stability of fired materials during steam exposure were determined. It was found that dolomite sludge contains more clay minerals and less carbonates, it is more finely grained than limestone sludge. Limestone sludge has large fluctuations in water content and has high content of potentially hazardous calcite grains. During heating up to 1300°C of both dried sludges decarbonation and sintering take place. Dolomite sludge softens, melts and flows below 1300°C. After firing sludges at 1000°C material made of limestone sludge is not resistant to steam. The obtained result suggests that dolomite sludge can be used in building ceramics technology without processing as main component of ceramic mass. Limestone sludge have to be ground before its application in building ceramic materials. Results suggest that it can not be used as the main raw material in ceramic masses, but only as an additive.
The article presents results of the author’s bachelor thesis, which deals with detailed cataloguing and analysing of findings of so-called Scythian character in the Moravia in the late Early Iron Age period. The author based this article on catalogue from his thesis. Relevant analogies and typological assignments were studied for concerning every subject in the catalogue and on their basis there was made general chronological classification of each piece. The aim of this article is to present observations that resulted from a detailed evaluation, on its basis occurrence of the subjects of so-called Scythian origin in the Moravia were divided into three time horizons.
A large number of infrastructural concrete buildings are protected against aggressive environments by coating systems. The functionality of these coating systems is mainly affected by the composition and thickness of the individual polymeric layers. For the first time ever, a mobile nuclear magnetic resonance (NMR) sensor allows a non-destructive determination of these important parameters on the building site. However, before this technique can be used on steel-reinforced concrete elements, the potential effect of the reinforcement on the measurement, i.e. the NMR signal, needs to be studied. The results show a shift of the NMR profile as well as an increase of the signals amplitude in the case of the reinforced samples, while calculating the thickness of concrete coating leading to identical results.
Two fundamental challenges in investigation of nonlinear behavior of cantilever beam are the reliability of developed theory in facing with the reality and selecting the proper assumptions for solving the theory-provided equation. In this study, one of the most applicable theory and assumption for analyzing the nonlinear behavior of the cantilever beam is examined analytically and experimentally. The theory is concerned with the slender inextensible cantilever beam with large deformation nonlinearity, and the assumption is using the first-mode discretization in dealing with the partial differential equation provided by the theory. In the analytical study, firstly the equation of motion is derived based on the theory of large deformable inextensible beam. Then, the partial differential equation of motion is discretized using the Galerkin method via the assumption of the first mode. An exact solution to the obtained nonlinear ordinary differential equation is developed, because the available semi analytical and approximated methods, due to their limitations, are not always sufficiently reliable. Finally, an experiment set-up is developed to measure the nonlinear frequency of oscillations of an aluminum beam within a domain of initial displacement. The results show that the proposed analytical method has excellent convergence with experimental data.