Search results

Filters

  • Journals
  • Authors
  • Keywords
  • Date
  • Type

Search results

Number of results: 3
items per page: 25 50 75
Sort by:

Abstract

The paper presents the experimental study of a novel unsteady-statemembrane gas separation approach for recovery of a slow-permeant component in the membrane module with periodical retentate withdrawals. The case study consisted in the separation of binary test mixtures based on the fast-permeant main component (N2O, C2H2) and the slow-permeant impurity (1%vol. of N2) using a radial countercurrent membrane module. The novel semi-batch withdrawal technique was shown to intensify the separation process and provide up to 40% increase in separation efficiency compared to a steady-state operation of the same productivity.
Go to article

Abstract

This paper presents an effect of general dimensions of a reverse flow mini-cyclone with a tangential inlet on its separation efficiency. Several mini-cyclone design modifications are presented and evaluated for use in the air filtration systems of motor vehicles. Local design improvements of three components of a reverse flow mini-cyclone with a tangential inlet D-40 of an air filter fitted in an all-terrain vehicle engine were introduced. An asymmetric curvilinear shape of an outlet port was used instead of a symmetrical shape. An outlet vortex finder inlet port shape was streamlined, and a cylindrical outlet vortex finder of the cyclone was replaced with a conical one. Experimental evaluation of the effects of the design improvements of mini-cyclone on its separation efficiency and performance as well as flow resistance was carried out. Separation efficiency of the cyclone was determined using the mass method as a product of dust mass retained by the mini-cyclone and supplied to the mini-cyclone in a specified time. Separation performance of the cyclone was determined as the largest dust particle dz =dzmax in a specific test cycle in the cyclone outlet air stream. A polydisperse PTC-D test dust used in Poland, a substitute for AC-fine test dust was used. Dust concentration at the mini-cyclone inlet was kept at 1 g/m3. The size and total number of dust particles in the air stream at the outlet of the original mini-cyclone and at the outlet of the improved mini-cyclone was determined using a particle counter.
Go to article

Abstract

This article describes a thermodynamic analysis of an oxy type power plant. The analyzed power plant consists of: 1) steam turbine for supercritical steam parameters of 600 °C/29 MPa with a capacity of 600 MW; 2) circulating fluidized bed boiler, in which brown coal with high moisture content (42.5%) is burned in the atmosphere enriched in oxygen; 3) air separation unit (ASU); 4) CO2 capture installation, where flue gases obtained in the combustion process are compressed to the pressure of 150 MPa. The circulated fluidized bed (CFB) boiler is integrated with a fuel dryer and a cryogenic air separation unit. Waste nitrogen from ASU is heated in the boiler, and then is used as a coal drying medium. In this study, the thermal efficiency of the boiler, steam cycle thermal efficiency and power demand were determined. These quantities made possible to determine the net efficiency of the test power plant.
Go to article

This page uses 'cookies'. Learn more