Search results

Filters

  • Journals
  • Authors
  • Keywords
  • Date
  • Type

Search results

Number of results: 4
items per page: 25 50 75
Sort by:

Abstract

Heavy minerals in sandur deposits from the forefield of the Renard Glacier were investigated. They are concentrated only in fractions below 0.1 mm in diameter. Composition and preservation of heavy minerals indicate very high dynamic in the sedimentary environment. Most resistant minerals as zircon and tourmaline predominate and are strongly crumbled. They probably may serve as mineral indicators of sandur deposits. If distinguished regularities are confirmed in forefield in other Spitsbergen sandurs, then contemporary and Pleistocene sandur deposits could be compared. No mineralogie differentiation of intra- and extramorainal sandurs was noted.
Go to article

Abstract

Mineral composition of bedrock is the main factor determining salt mineralization in the weathering zone of Seymour (Marambio) Island (maritime — Antarctic continent climatic boundary). Supply of salts by sea water spray can accelerate weathering process, modify chemical formula of salt minerals and give ephemeral efflorescences of easy soluble chlorides and partially longer lasting gypsum on the surface. Microbiologically mediated oxidation of sulphides and followed acid sulphate drainage formed K and Na jarosite, basic amorphous aluminium sulphate, gypsum, aluminium bearing ferrihydrite and ankerite in weathering zone of Paleogene sediments. Intense alteration of well-lithified, calcareous sandstones of unit 1 of the López de Bertodano Formation (Cretaceous) on old erosion surface led localy to surface mineralization comparable with that found in Antarctic Continent. Stones laying on the soil surface are covered by thin red film of ferrihydrite above the soil level and by light green crust of aragonite coloured by glauconite pigment on the underground side. Most of the Cretaceous sediment does not contain sulphides nor alteration susceptible silicates thus ephemeral sea salts efflorescences observed on its surface are more prominent than in another places.
Go to article

Abstract

It is estimated that the amount of used car tires in the European Union in 2016 was established at the level of 3,515,000 Mg, which is undoubtedly a problem from the point of view of engineering and environmental protection. An alternative to storing this waste in landfills is their pyrolysis. As a result of thermal decomposition, calorific value products (oil and gas fraction) are obtained, as well as a solid residue, which due to its composition and properties can be processed into a high quality carbon sorbent. For this purpose, various methods of modification of the pyrolyzate are used, both involving physical and chemical activation. This article presents the characteristics of solid residue after the pyrolysis of rubber tires running at a temperature of about 400°C, which included an analysis of chemical composition (XRF and IR), mineralogical composition (XRD, SEM-EDS) and textural characteristics. Additionally, for the purpose of activation, the sample was treated with nitrogen at a temperature of 550°C. The mineralogical analysis showed that the dominant mineral component is carbon. In addition, the presence of quartz, calcite and sphalerite was observed. Analysis of the chemical composition suggests that due to the high carbon content (about 80% by mass) it is possible for a carbon sorbent from the analyzed waste to be obtained. However, previous preliminary studies did not allow a material constituting a substitute for activated carbon to be obtained, because the applied modification only slightly increased the BET specific surface area, which reached the value of approx. 85 m2/g. Based on the analysis of the pore size distribution of the 2 tested samples, it was found to be homogeneous/modal with a micro/mesoporous nature, while the shape of the hysteresis loop suggests the presence of “bottle shape” pores. Due to the relatively high content of zinc, the composition of waste (about 4% of mass), the possibility of recovery of this element should also be considered.
Go to article

Abstract

In the Polish sector of the Magura Nappe have long been known and exploited carbonate mineral waters, saturated with carbon dioxide, known as the “shchava (szczawa)”. These waters occur mainly in the Krynica Subunit of the Magura Nappe, between the Dunajec and Poprad rivers, close to the Pieniny Klippen Belt (PKB). The origin of these waters is still not clear, this applies to both “volcanic” and “metamorphic” hypotheses. Bearing in mind the case found in the Szczawa tectonic window and our geological and geochemical studies we suggest that the origin of the carbon dioxide may be linked with the thermal/pressure alteration of organic matter of the Oligocene deposits from the Grybów Unit. These deposits, exposed in several tectonic windows of the Magura Nappe, are characterized by the presence of highly matured organic matter – the origin of the hydrocarbon accumulations. This is supported by the present-day state of organic geochemistry studies of the Carpathian oil and gas bed rocks. In our opinion origin of the carbon-dioxide was related to the southern, deep buried periphery of the Carpathian Oil and Gas Province. The present day distribution of the carbonated mineral water springs has been related to the post-orogenic uplift and erosion of the Outer (flysch) Carpathians.
Go to article

This page uses 'cookies'. Learn more