Economic development is strictly dependent on access to inexpensive and reliable energy sources based on diversified primary fuels. The strategic framework for the construction of the energy mix is defined in the Energy Policy of the State, the content of which, in terms of its mandatory elements, has been specified in the Energy Law. The task of the Energy Policy of the State is to create the shape of the future power sector, including designing the most advantageous regulatory, system and technical solutions guaranteeing the appropriate level of energy security of the country, monitoring of the system’s evolution and also designing and implementing changes aimed at the optimization of the functioning mechanisms. The vision of the development of the power system at the global level should also reflect changes in the formation of dispersed civil energy structures. Unfortunately, the results of the conducted analyses reveal existing imperfections of the data acquisition and information system, which should be used in the planning process. This issue is particularly important from the perspective of the dynamically developing concept of the energy self-sufficiency of communes and the emergence of energy clusters. The present paper describes the functioning of strategic planning in the field of the electric power system with an illustration of the improperly functioning mechanisms of information transfer in the context of the advancement of dispersed civil energy structures.
Hybrid Renewable Energy Systems connected to the traditional power suppliers are an interesting technological solution in the field of energy engineering and the integration of renewable systems with other energy systems can significantly increase in energy reliability. In this paper, an analysis and optimization of the hybrid energy system, which uses photovoltaic modules and wind turbines components connected to the grid, is presented. The system components are optimized using two objectives criteria: economic and environmental. The optimization has been performed based on the experimental data acquired for the whole year. Results showed the optimal configuration for the hybrid system based on economical objective, that presents the best compromise between the number of components and total efficiency. This achieved the lowest cost of energy but with relatively high CO2 emissions, while environmental objective results with lower CO2 emissions and higher cost of energy and presents the best compromise between the number of components and system net present cost. It has been shown that a hybrid system can be optimized in such a way that CO2 emission is maximally reduced and – separately – in terms of reducing the cost. However, the study shows that these two criteria cannot be optimized at the same time. Reducing the system cost increase CO2 emission and enhancing ecological effect makes the system cost larger. However, depends on strategies, a balance between different optimization criteria can be found. Regardless of the strategy used economic criteria – which also indirect takes environmental aspects as a cost of penalties – should be considered as a major criterion of optimization while the other objectives including environmental objectives are less important.
The paper looks at the issues of operation safety of the national power grid and the characteristics of the national power grid in the areas of transmission and distribution. The issues of operation safety of the national transmission and distribution grid were discussed as well as threats to operation safety and security of the electricity supply related to these grids. Failures in the transmission and distribution grid in 2017, caused by extreme weather conditions such as: a violent storm at the night of 11/12.08.2017, hurricane Ksawery on 5–8.10.2017, and hurricane Grzegorz on 29–30.10.2017, the effects of which affected tens of thousands of electricity consumers and led to significant interruptions in the supply of electricity were presented. At present, the national power (transmission and distribution) grid does not pose a threat to the operation safety and security of the electricity supply, and is adapted to the current typical conditions of electricity demand and the performance of tasks during a normal state of affairs, but locally may pose threats, especially in extreme weather conditions. A potentially high threat to the operation safety of the national power grid is closely linked to: age, technical condition and the degree of depletion of the transmission and distribution grids, and their high failure rate due to weather anomalies. Therefore, it is necessary to develop and modernize the 400 and 220 kV transmission grids, cross-border interconnections, and the 110 kV distribution grid (especially in the area of large urban agglomerations), and the MV distribution grid (especially in rural areas). The challenges faced by the transmission and distribution grid operators within the scope of investment and operating activities, with a view to avoiding or at least reducing the scale of grid failures in the case of future sudden high-intensity atmospheric phenomena, are presented.
The article concerns safety of power supply for the final consumers, especially its two comprising elements, which are generation adequacy and distribution system reliability. Generation adequacy has been defined with Loss of Load Probability (LOLP), Loss of Load Expectation (LOLE) and Energy Not Supplied (ENS) indices. Conclusions from generation adequacy forecast prepared by ENSTO-E for Poland compared with other European countries for the years 2020 and 2025 have been discussed along with the resulting threats. Interruptions in energy supply have been characterised by power discontinuity indicator SAIDI. Finally, a reliability and adequacy analysis have been performed for different scenarios of the Polish power system operation in order to assess possibilities of using distributed generation as a backup power source. Based on a simulation model created using the DIgSILENT Power Factory software, the reliability and adequacy calculations have been performed with the probabilistic non-sequential Monte Carlo method and they are followed by a discussion of the obtained results.