Search results

Filters

  • Journals
  • Date

Search results

Number of results: 6
items per page: 25 50 75
Sort by:

Abstract

The article discusses the weldment to casting conversion process of rocker arm designed for operation in a special purpose vehicle to obtain a consistency of objective functions, which assume the reduced weight of component, the reduced maximum effort of material under the impact of service loads achieved through topology modification for optimum strength distribution in the sensitive areas, and the development of rocker arm manufacturing technology. As a result of conducted studies, the unit weight of the item was reduced by 25%, and the stress limit values were reduced to a level guaranteeing safe application.
Go to article

Abstract

This work examines the reduced-cost design optimization of dual- and multi-band antennas. The primary challenge is independent yet simultaneous control of the antenna responses at two or more frequency bands. In order to handle this task, a feature-based optimization approach is adopted where the design objectives are formulated on the basis of the coordinates of so-called characteristic points (or response features) of the antenna response. Due to only slightly nonlinear dependence of the feature points on antenna geometry parameters, optimization can be attained at a low computational cost. Our approach is demonstrated using two antenna structures with the optimum designs obtained in just a few dozen of EM simulations of the respective structure.
Go to article

Abstract

In this paper, a novel structure of a compact UWB slot antenna and its design optimization procedure has been presented. In order to achieve a sufficient number of degrees of freedom necessary to obtain a considerable size reduction rate, the slot is parameterized using spline curves. All antenna dimensions are simultaneously adjusted using numerical optimization procedures. The fundamental bottleneck here is a high cost of the electromagnetic (EM) simulation model of the structure that includes (for reliability) an SMA connector. Another problem is a large number of geometry parameters (nineteen). For the sake of computational efficiency, the optimization process is therefore performed using variable-fidelity EM simulations and surrogate-assisted algorithms. The optimization process is oriented towards explicit reduction of the antenna size and leads to a compact footprint of 199 mm2 as well as acceptable matching within the entire UWB band. The simulation results are validated using physical measurements of the fabricated antenna prototype.
Go to article

Abstract

A new Computer-Aided Design approach is introduced for design of steel castings taking into account the feeding ability in sand moulds. This approach uses the geometrical modeling by a CAD-program, in which the modul “Castdesigner” is implemented, which includes the feeding models of steel castings. Furthermore, the feeding ability is guaranteed immediately during the design by an interactive geometry change of the casting cross section, so that a directional feeding of the solidifying casting from the installed risers is assured.
Go to article

Abstract

In the paper, a general topology of continuous-time Active-RC filter is presented. The model includes all possible Active-RC filter structures as particular cases and allows us to analyze them using a unified algebraic formalism. This makes it suitable for use in computeraided analysis and design of Active-RC filters. By its construction, the model takes into account the finite DC gain and the finite bandwidth as well as non-zero output resistance of operational amplifiers. Filters with ideal OPAMPs can be treated as particular cases. Sensitivity and noise analysis of Active-RC filters is also performed in the proposed general setting. The correctness of the model is verified by comparison with SPICE simulation.
Go to article

This page uses 'cookies'. Learn more