Touch-trigger probes for CNC milling machines usually use wireless communication in the radio or IR band. Additionally they enable triggering signal filtering in order to avoid false triggers of the probe. These solutions cause a delay in trigger signal transmission from the probe to the machine tool controller. This delay creates an additional pre-travel component, which is directly proportional to the measurement speed and which is the cause of a previously observed but not explained increase of the pre-travel with the increase of the measurement speed. In the paper, a method of testing the delay time of triggering signal is described, an example of delay time testing results is presented and the previous, unexplained results of other researchers are analysed in terms of signal transmission delay.
This paper deals with production of safety inlay for steam locomotive valve by the Patternless Process method. For the moulds creation was used moulding mixtures of II. generation, whereas binder was used a water glass. CNC miller was used for creation of mould cavity. Core was created also by milling into block made of moulding compound. In this article will be presented also making of 3D model, setting of milling tool paths and parameters for milling.
The paper presents the results of research work on the development of a rapidprototyping test stand for testing: servo control algorithms, trajectory generation, algorithms for increasing overall quality of the feed-drive modules within two axis (X-Y) table of the milling machine. Open architecture interface of the prepared control system lets the potential user test functionality of integration of diagnostic tools within the motion controller - directly, without taking into account communication with top-level CNC system.