Search results

Filters

  • Journals
  • Authors
  • Date
  • Type

Search results

Number of results: 28
items per page: 25 50 75
Sort by:

Abstract

Recent archaeological discoveries have allowed us to examine a series of bracteates from East Pomerania from the late twelfth and the thirteenth century, which has enabled us to construct a new view of medieval coinage in this province. A pivotal role may be attributed to the coins inscribed with the name of Sambor I, the fi rst historical master of Gdańsk, and with the monogrammed name of Otto, which is supposed to refer to St Otto of Bamberg.
Go to article

Abstract

The subject of the work is the recognition and analysis of nine coins from the 15th–20th centuries, found during archaeological exploration of a site at the Market Square in Barczewo (Warmian-Masurian Voivodeship).
Go to article

Abstract

The paper describes experimental research on a resistojet type rocket thruster which was built as an actuator in the Attitude Control System of a model space robotic platform. A key element of the thruster is the heater responsible for increasing the temperature of the working medium in the thruster chamber and hence the specific impulse. This parameter describes the performance of the thruster, increases providing – for lower propellant consumption – the same propulsion effect (thrust). A high performance thruster means either total launch mass can be reduced or satellite lifetime increased, which are key commercial factors. During the first phase of the project, 7 different heating chamber designs were examined. The heater is made of resistive wire with resistivity of 9Ω/m. Power is delivered by a dedicated supply system based on supercapacitors with output voltage regulated in the range of 20–70 V. The experimental phase was followed by designing the chamber geometry and the heating element able to deliver both: maximum increase of gas temperature and minimum construction dimensions. Experiments with the optimal design show an increase in temperature of the working gas (air) by about 300 ◦C giving a 40% increase in specific impulse. The final effect of that is a 40% reduction in mass flow rate while retaining thrust at a nominal level of 1 N.
Go to article

Abstract

In this work studies ofM OVPE growth of InAlGaAs/AlGaAs/GaAs heterostructures are presented. The HRXRD and SIMS measurements indicate the high structural and optical properties as well as high uniformity oft hickness and composition ofI nAlGaAs quantum wells. This work is the .rst step towards elaboration oft he technology oft he strained InAlGaAs/GaAs heterostructures for advanced optoelectronic devices working in the visible part oft he spectrum. The investigations ofSi (n-type), Zn (p-type) .-doped GaAs epilayers and centre Si-.-doped InxGa1-xAs single quantum well (SQW) are presented. The .-doping layer was formed by SiH4 or DEZn introduction during the growth interruption. The electrical and optical properties oft he obtained structures were examined using C-V measurement, EC-V electrochemical pro.ler, Raman spectroscopy (RS), photore.ectance (PR) and photocurrent (PC) spectroscopies. Technology oft hick GaN layers grown on sapphire by HVPE is very promising as a part off reestanding GaN substrates manufacturing. Further works will be focused on the optimisation of growth, separating layers from substrates and surface polishing. The in.uence oft he growth parameters on the properties of( Ga, Al)N/Al2O3 and Mg dopant incorporation was studied.
Go to article

Abstract

The article refers to the idea of using the software defined network (SDN) as an effective hardware and software platform enabling the creation and dynamic management of distributed ICT infrastructure supporting the rapid prototyping process. The authors proposed a new layered reference model remote distributed rapid prototyping that allows the development of heterogeneous, open systems of rapid prototyping in a distributed environment. Next, the implementation of this model was presented in which the functioning of the bottom layers of the model is based on the SDN architecture. Laboratory tests were carried out for this implementation which allowed to verify the proposed model in the real environment, as well as determine its potential and possibilities for further development. Thus, the approach described in the paper may contribute to the development and improvement of the efficiency of rapid prototyping processes which individual components are located in remote industrial, research and development units. Thanks to this, it will be possible to better integrate production processes as well as optimize the costs associated with prototyping. The proposed solution is also a response in this regard to the needs of industry 4.0 in the area of creating scalable, controllable and reliable platforms.
Go to article

Abstract

Steroidal saponins isolated from many plant species belonging to Monocotyledones display potent cytotoxic activity towards many human tumor cells. We examined the cytotoxic effects of crude Paris quadrifolia extract for the first time, testing isolated saponin-rich fractions against four different human cell lines using the [(3-(4,5-dimethylthiazol-2-yl)]-2,5-diphenyltetrazolium bromide (MTT) assay. Cytotoxic activity was tested against human promyelocytic leukemia (HL-60) cells, human cervical adenocarcinoma (HeLa) cells and human breast cancer (MDA-MB-468) cells. Human skin fibroblasts were used as non-neoplastic control cells. Our results show significant activity of the weakly water-soluble solid residue and butanolic fraction against HL-60 and HeLa cells. The solid residue exerted cytotoxicity against all tested cell lines.
Go to article

This page uses 'cookies'. Learn more