Praca zawiera analizy i oceny skutków wybranych regulacji polskiego prawa dotyczących gospodarki przestrzennej, zwłaszcza planowania przestrzennego. Różni się od poprzednich raportów położeniem większego nacisku na bariery blokujące naprawę wadliwego systemu publicznego zarządzania przestrzenią. Praca nie jest próbą oceny prawa pod względem jego poprawności jurydycznej i legislacyjnej.
Studies of electrical properties, including noise properties, of thick-film resistors prepared from various resistive and conductive materials on LTCC substrates have been described. Experiments have been carried out in the temperature range from 300 K up to 650 K using two methods, i.e. measuring (i) spectra of voltage fluctuations observed on the studied samples and (ii) the current noise index by a standard meter, both at constant temperature and during a temperature sweep with a slow rate. The 1/f noise component caused by resistance fluctuations occurred to be dominant in the entire range of temperature. The dependence of the noise intensity on temperature revealed that a temperature change from 300 K to 650 K causes a rise in magnitude of the noise intensity approximately one order of magnitude. Using the experimental data, the parameters describing noise properties of the used materials have been calculated and compared to the properties of other previously studied thick-film materials.
Studies of noise properties of thick-film conducting lines from Au or PdAg conductive pastes on LTCC or alumina substrates are reported. Experiments have been carried out at the room temperature on samples prepared in the form of meanders by traditional screen-printing or laser-shaping technique. Due to a low resistance of the devices under test (DUTs), low-frequency noise spectra have been measured for the dc-biased samples arranged in a bridge configuration, transformer-coupled to a low-noise amplifier. The detailed analysis of noise sources in the signal path and its transfer function, including the transformer, has been carried out, and a procedure for measurement setup self-calibration has been described. The 1/f noise component originating from resistance fluctuations has been found to be dominant in all DUTs. The analysis of experimental data leads to the conclusion that noise is produced in the bends of meanders rather than in their straight segments. It occurs that noise of Au-based laser-shaped lines is significantly smaller than screen-printed ones. PdAg lines have been found more resistive but simultaneously less noisy than Au-based lines.
The suitability of low-cost impedance sensors for microbiological purposes and biofilm growth monitoring was evaluated. The sensors with interdigitated electrodes were fabricated in PCB and LTCC technologies. The electrodes were golden (LTCC) or gold-plated (PCB) to provide surface stability. The sensors were used for monitoring growth and degradation of the reference ATCC 15442 Pseudomonas aeruginosa strain biofilm in invitro setting. During the experiment, the impedance spectra of the sensors were measured and analysed using electrical equivalent circuit (EEC) modelling. Additionally, the process of adhesion and growth of bacteria on a sensor’s surface was assessed by means of the optical and SEM microscopy. EEC and SEM microscopic analysis revealed that the gold layer on copper electrodes was not tight, making the PCB sensors susceptible to corrosion while the LTCC sensors had good surface stability. It turned out that the LTCC sensors are suitable for monitoring pseudomonal biofilm and the PCB sensors are good detectors of ongoing stages of biofilm formation.
Contemporary changes of socio-economic development factors. The aim of the work is to determine the scope of contemporary changes of socio-economic development factors, paying attention to the consequences for their interpretation and mechanism of impact relating to the regional and local level. The main goal is specified by formulating the following research questions: (1) What major megatrends shape contemporary developmental transformations? (2) What is the direction and scope of changes in socio-economic development factors? (3) How are the conditions of development processes changing as a result of these changes and how they differentiate the processes of development in space? The article is a synthesis of the results of two research projects of the National Science Center: NN 306 79 19 40: Socio-economic development and the development of areas of growth and areas of economic stagnation (2011–2014) and OPUS 10 – 2015/19/B/HS5/00012: New challenges of regional policy in shaping the factors of socio-economic development of less developed regions (2016–2019) and the results of own authors’ research – employees of the Regional Analysis Department at the Institute of Socio-Economic Geography and Spatial Management of the Adam Mickiewicz University in Poznań.
The main subject of research in this paper is glauconite with its useful parameters, which is the object of exploitation in the “Górka Lubartowska-Niedźwiada” deposit. The main glauconitic horizon (lower Eocene) is built by loamy fine-grained and medium greenish sands with marine fauna and fragments of amber (ca. 7 m thick). Thin lamins and pockets of silts containing phosphorites and also glauconitic sands with underlaying very thin quartz-glauconitic sands are found at the bottom of this layer. The glauconite deposit in “Górka Lubartowska-Niedźwiada” is an amount of ca. 30% by volume of the main glauconitic horizon. Glauconite of the 1M polytype (XRD) shows large granulometric and morphological differentiation (SEM-EDS). It frequently contains aggregations of euhedral or framboidal pyrite grains (RS), which is indicative of the euxinic nature of the formation environment of the rocks under study. The individual glauconite grains show distinct chemical variability, manifested in a lower share of Al2O3 and an increased content of MgO and CaO (EPMA, XRF). At the same time, a large share of K2O (above 8% by weight) allows it to be included in highly matured glauconite, thus it can be considered as a potential raw material for the production of mineral fertilizers. The association of glauconite with phosphates (SEM-EDS) and anatase inclusions in the grains of glauconite (RS) indirectly point to the contribution of the decomposing organic matter to the formation of grains of this mineral. The xylite fragments preserved in the sediment show a low degree of coalification, which is typical of soft lignite. This also shows that the transformation process was taking place under a relatively small overburden.