In the article, the characterization of the microstructure, phase composition and distribution of elements in the Eu2O3-ZrO2 sintered materials obtained by four different ways of powders’ homogenization (mixing) process and different temperature of sintering process is shown. The feedstock powders with an average mole ratio of ZrO2 to Eu2O3 equal 74% to 26% were used as an initial material. The principal aim of the investigation was characterization of differences in the microstructure of the same type of ceramics, however, prepared via different mixing and manufacturing processes. The range of the investigation covered a characterization of these materials via phase identification of all samples by XRD (X-ray diffraction) and characterization of internal morphology of the specimens with detailed analysis of elements distributions by SEM (scanning electron microscopy) and EDS (energy dispersive spectrometry). The aim of the following investigation is to characterize the possibilities of the solid state synthesis of the europium zirconate based materials, dedicated for TBC applications.
In the present paper the structure and thermal properties of europium cerium oxides were investigated. The material for the research was obtained via solid state synthesis. The initial powders: ceria CeO2 and europia Eu2O3 were mixed in 1:1 mass ratio (non-stoichiometric proportion with the excess of CeO2) and milled. The sintering process was performed using high temperature vacuum press at 1350°C. Calorimetric analysis was conducted both for initial powders and milled mixture. The structure, phase composition and thermal diffusivity of obtained material were investigated in as-sintered condition. It was revealed that the obtained material was multi-phase. Non-stoichiometric phases including Ce0.5Eu0.5O1.75 with fluorite type structure and different lattice parameters were present. Thermal diffusivity decreased in the range from 25 to 900°C from 1.49 to 0.57 mm2/s and then increased to 0.70 mm2/s at 1400°C.
The primary microstructure of new Co-based superalloy of Co-20Ni-7Al-7W (at.%) type was showed in this article. The alloy was manufactured by induction melting in vacuum furnaces. This alloy is a part of new group of high-temperature materials based on Co solid solution and strengthened by coherent L12 phase similar to Ni-based superalloys with γʹ phase. The final form of Coss/L12 microstructure is obtained after fully heat treatment included homogenization, solutionizing and aging processes. But first step of heat treatment thermal parameters determination is characterization of primary microstructure of alloys after casting process with special attentions on segregations of alloying elements in solid solution and presences of structural elements such as eutectic areas, and other phases precipitations. In analysed case the relatively high homogeneity of chemical composition was expected especially in the case of W distribution, what was confirmed be SEM/EDS analysis in dendritic and interdendritic areas.