Search results

Filters

  • Journals
  • Date

Search results

Number of results: 24
items per page: 25 50 75
Sort by:

Abstract

Despite the consensus on the role of lung and pleura ultrasound in human medicine, veteri- nary medicine questions credibility of the pulmonary evaluation in ultrasound examination, based on the analysis of artifacts in animals with clinical signs of respiratory failure and possibility of pulmonary edema diagnosis with recognition of the degree of its severity. The study was conduct- ed on 47 animals (29 dogs and 18 cats) of different breeds, age and sex. In all of animals prior to the transthoracic lung and pleura ultrasound examination (TLPUS), all animals were subjected to a clinical examination and hematological blood test as well as chest radiography examination in three projections. Ultrasound imaging of the chest in each animal was performed at designated four defined segments. TLPUS in dogs and cats based on an analysis of artifacts allows recogni- tion of pulmonary edema, to the degree comparable to chest X-ray examination. The number of depicted B-lines artifacts is proportional to the degree of pulmonary edema. These results allow to reduce the number of radiographs and allow the shortening of the diagnostic process for pa- tients in life-threatening condition.
Go to article

Abstract

The analysis of influence of mould withdrawal rate on the solidification process of CMSX-4 single crystal castings produced by Bridgman method was presented in this paper. The predicted values of temperature gradient, solidification and cooling rate, were determined at the longitudinal section of casting blade withdrawn at rate from 1 to 6mm/min using ProCAST software. It was found that the increase of withdrawal rate of ceramic mould results in the decrease of temperature gradient and the growth of cooling rate, along blade height. Based on results of solidification parameter G/R (temperature gradient/solidification rate), maximum withdrawal rate of ceramic mould (3.5 mm/min), which ensures lower susceptibility to formation process of new grain defects in single crystal, was established. It was proved that these defects can be formed in the bottom part of casting at withdrawal rate of 4 mm/min. The increase of withdrawal rate to 5 and 6 mm/min results in additional growth of susceptibility of defects formation along the whole height of airfoil.
Go to article

This page uses 'cookies'. Learn more