Measurements of water temperatures, salinity, oxygen, suspended matter, nutrients and some metals contents were determined in the waters of the Hornsund Fjord. The investigations were carried out at the end of June and July and in mid-September 1979.
The article presents research results of physico-chemical and environmental issues for the dust generated during dedusting of the installation for the processing and preparation of moulding sand with bentonite. Particular attention was paid to the content of heavy metals and emission of gases from the BTEX group, which is one of the determinants of the moulding sands harmfulness for the environment. The analysis of heavy metals in the test samples indicate that there is an increase of the content of all metals in the dust compared to the initial mixture of bentonite. The most significant (almost double) increase observed for zinc is probably related to the adsorption of this element on the dust surface by contact with the liquid metal. The study showed, that dust contained more than 20% of the amount of montmorillonite and had a loss on ignition at a similar level. The addition of 1% of dust to the used moulding sand results in almost 30% increase in the total volume of gases generated in casting processes and nearly 30% increase of the benzene emission.
The aim of the study was evaluation of ecological potential of reservoirs, once complexes of fish ponds, which are currently covered by international form of nature conservation. An effort to identify the source of reservoirs’ water supply in biogenic substances has also been undertaken. Studied dam reservoirs, included in Natura 2000 site: a Special Protection Area (SPA) called ‘Uroczysko Mosty--Zahajki’ (PLH060014). The ‘Uroczysko Mosty-Zahajki’ consists of two neighboring, not very deep reservoirs: Mosty (390 ha) and Zahajki (240 ha), located in the Hanna river’s catchment area, a tributary of the Bug and Zielawa rivers entering the Krzna river. Studied reservoirs represented moderate (reservoir Zahajki) and bad (Mosty reservoir) ecological potential. The buffer zones of Mosty and Zahajki reser-voirs were dominated by large forest complexes. The studied reservoirs are supplied with rivers and ditches contaminated with nutrients. Mosty and Zahajki reservoirs, in spite of moderate and poor ecologi-cal potential, increase the water resources of the area, have a positive impact on the circulation of water and increase the landscape and recreational values of region.
Studies on biocompatibility of AISI 316LVM steel indicate the need to eliminate the nickel from the surface and replace it with other elements of improved biocompatibility. Therefore, in the presented work selected physicochemical and mechanical properties of the diffusive nitrocarburized layer formed by plasma potential by means of an active screen made of the Fe-Cr-Ni were studied. In the paper we present results of microstructure and phase composition of the layers, roughness, and surface wettability, potentiodynamic pitting corrosion resistance, penetration of ions into the solution as well as mechanical properties. The studies were conducted for the samples of both mechanically polished and nitrocarburized surfaces, after sterilization, and exposure to the Ringer’s solution. Deposition of the nitrocarburized layer increased the contact angle, surface roughness, surface hardness, and corrosion resistance with respect to the polished surfaces. The nitrocarburized layer is a barrier against the ions release into the solution and sterilization and exposure to Ringer solution. The obtained results showed beneficial increase of both mechanical and electrochemical properties of the deposited layer, and thus the applicability of the proposed method of surface treatment of the 316LVM steel for short-term implants after sterylization.