Thermo-chemical treatments are known to increase the fatigue life of industrial parts. Due to the imprecise consideration of residual stresses in predicting the durability of components subjected to cyclic loading and their effect on the fatigue life, the authors developed a numerical model combining the influence of residual stresses with stresses caused by bending. The authors performed the numerical simulation with the use of Finite Element Method to analyse material behaviour during cyclic loading. The residual stress state developed during nitriding was introduced onto cross-section of the numerical specimen. The goal of this work was better understanding of the real conditions of the nitride steel fatigue processes and improving the knowledge about numerical predicting of the fatigue life for parts with residual stresses. The results of simulation were compared with plane bending fatigue tests. The presented method indicates the possibility of increasing the accuracy of the fatigue analysis of elements after surface treatment, increasing its certainty and the ability to perform better optimization of service life.
In this paper we propose an original configuration of a compliant mini-gripper for handling chemicals. The compliant mini-gripper is 3D modeled and analyzed with finite element method. To use it in a wider range of containers designed for laboratories we made several variants of fasteners. In order to obtain a functional prototype in a scale appropriate to characterize the system, we determined the material properties of the gripper and developed an experimental stand for characterizing the system with mini-gripper. Finally, we compared the movements of the experimental grip, made according to the movement of the bellows type actuator, determined based on, analytical and numerical results.
The rigid finite element method (RFEM) has been used mainly for modelling systems with beam-like links. This paper deals with modelling of a single set of electrodes consisting of an upper beam with electrodes, which are shells with complicated shapes, and an anvil beam. Discretisation of the whole system, both the beams and the electrodes, is carried out by means of the rigid finite element method. The results of calculations concerned with free vibrations of the plates are compared with those obtained from a commercial package of the finite element method (FEM), while forced vibrations of the set of electrodes are compared with those obtained by means of the hybrid finite element method (HFEM) and experimental measurements obtained on a special test stand.
The need to reduce pollutant emissions leads the engineers to design new aeronautic combustors characterized by lean burn at relatively low temperatures. This requirement can easily cause flame instability phenomena and consequent pressure pulsations which may seriously damage combustor’s structure and/or compromise its fatigue life. Hence the need to study the combustor’s structural dynamics and the interaction between elastic, thermal and acoustic phenomena. Finite element method represent a largely used and fairly reliable tool to address these studies; on the other hand, the idealization process may bring to results quite far from the reality whereas too simplifying assumptions are made. Constraints modelling represent a key-issue for all dynamic FE analyses; a wrong simulation of the constraints may indeed compromise entire analyses although running on very accurate and mesh-refined structural models. In this paper, a probabilistic approach to characterize the influence of external constraints on the modal behaviour of an aircraft combustor-rig is presented. The finite element model validation was performed at first by comparing numerical and experimental results for the free-free condition (no constraints). Once the model was validated, the effect of constraints elasticity on natural frequencies was investigated by means of a probabilistic design simulation (PDS); referring to a specific tool developed in the ANSYS®software, a preliminary statistical analysiswas at performed via Monte-Carlo Simulation (MCS) method. The results were then correlated with the experimental ones via Response Surface Method (RSM).
Three-dimensional (3D) finite element analyses (FEA) are performed to simulate the local compression (LC) technique on the clamped single-edge notched tension (SE(T)) specimens. The analysis includes three types of indenters, which are single pair of cylinder indenters (SPCI), double pairs of cylinder indenters (DPCI) and single pair of ring indenters (SPRI). The distribution of the residual stress in the crack opening direction in the uncracked ligament of the specimen is evaluated. The outcome of this study can facilitate the use of LC technique on SE(T) specimens.