The issue of air pollution, resulting to a large extent from the use of fossil fuels for energy purposes, is one of the most serious environmental threats in several Polish cities, but also outside of them. The amount of pollutants emitted into the atmosphere translates into the living conditions of the inhabitants. The utilization of geothermal energy, which is a renewable and ecological source of energy, brings noticeable improvement in the quality of atmospheric air, as evidenced by signiﬁcant ecological effects achieved by working geothermal district heating plants. The paper presents results of comprehensive considerations focused on assessing the effects of utilization of geothermal water and energy in Poland. Issues related to the implementation of exploration works aimed at acquiring geothermal water resources, as well as environmental aspects of the use of geothermal waters and energy were discussed. The undertaken considerations have been directed at assessing whether the use of such a kind of renewable energy resources could have an impact on improving the living conditions of the local community.
Compared to other European countries, Poland has scarce drinking water resources and exhibits significant variation in annual runoff. On the other hand, the geothermal water resources present in sedimentary/structural basins, mostly in the Polish Lowlands and the Podhale geothermal system, not only provide a valuable source of renewable energy, which is utilized, although only to a limited extent, but can also be used for many other purposes. The paper presents the results of studies related to the desalination of low dissolved mineral content geothermal waters from the Bańska IG-1 well using a dual hybrid system based on ultrafiltration and reverse osmosis. The desalination of geothermal waters may be considered a possible solution leading to the decentralization of drinking water supply. In many cases, using cooled waters for drinking purposes may be considered an alternative method of disposing of them, in particular for open drain arrangements, i.e. where cooled water is dumped into surface waters.
In this paper, the thermodynamic investigation on the use of geothermal water (130°C as maximum) for power generation through a basic Rankine has been presented together with obtained main results. Six typical organic working fluids (i.e., R245fa, R141b, R290, R600, R152a, and 134a) were studied with modifying the input pressure and temperature to the turbine. The results show that there are no significant changes taking place in the efficiency for these working fluids with overheating the inlet fluid to the turbine, i.e., efficiency is a weak function of temperature. However, with the increasing of pressure ratio in the turbine, the efficiency rises more sharply. The technical viability is shown of implementing this type of process for recovering low temperature heat resource.
M embrane-based water desalination processes and hybrid technologies are often considered as a technologically and economically viable alternative for desalination of geothermal waters. This has been conﬁrmed by the results of pilot studies concerning the UF-RO desalination of geothermal waters extracted from various geological structures in Poland. The assessment of the feasibility of implementing the water desalination process analysed on an industrial scale is largely dependent on the method and possibility of disposing or utilising the concentrate. The analyses conducted in this respect have demonstrated that it is possible to use the solution obtained as a balneological product owing to its elevated metasilicic acid, ﬂuorides and iodides ions content. Due to environmental considerations, injecting the concentrate back into the formation is the preferable solution. The energy efﬁciency and economic analysis conducted demonstrated that the cost effectiveness of implementing the UF-RO process in a geothermal system on an industrial scale largely depends on the factors related to its operation, including without limitation the amount of geothermal water extracted, water salinity, the absorption parameters of the wells used to inject water back into the formation, the scale of problems related to the disposal of cooled water, local demand for drinking and household water, etc. The decrease in the pressure required to inject water into the formation as well as the reduction in the stream of the water injected are among the key cost-effectiveness factors. Ensuring favourable desalinated water sale terms (price/quantity) is also a very important consideration owing to the electrical power required to conduct the UF-RO process.
Exergy analysis of low temperature geothermal heat plant with compressor and absorption heat pump was carried out. In these two concepts heat pumps are using geothermal water at 19.5°C with spontaneous outflow 24 m3/h as a heat source. The research compares exergy efficiency and exergy destruction of considered systems and its components as well. For the purpose of analysis, the heating system was divided into five components: geothermal heat exchanger, heat pump, heat distribution, heat exchanger and electricity production and transportation. For considered systems the primary exergy consumption from renewable and non-renewable sources was estimated. The analysis was carried out for heat network temperature at 50/40°C, and the quality regulation was assumed. The results of exergy analysis of the system with electrical and absorption heat pump show that exergy destruction during the whole heating season is lower for the system with electrical heat pump. The exergy efficiencies of total system are 12.8% and 11.2% for the system with electrical heat pump and absorption heat pump, respectively.