Wyniki wyszukiwania

Filtruj wyniki

  • Czasopisma
  • Autorzy
  • Słowa kluczowe
  • Data
  • Typ

Wyniki wyszukiwania

Wyników: 5
Wyników na stronie: 25 50 75
Sortuj wg:

Abstrakt

The Intrauterine fetal development process is complicated and affected by many regulating factors such as maternal nutritional status, transcription factors and adipokines. Adipokines are kinds of active substances secreted by adipose tissue, including more than 50 kinds of molecules. To explore the correlation between calf birth weights and adipokines including adiponectin, leptin, visfatin, and IGF-1 in cows venous and venous cord blood. Fifty-four healthy multiparous Chinese Holstein cows were used; in which, cows with a calf weight less than 40 kg were included in group A (n=9); those with a calf weight between 40 kg~45 kg were included in group B (n=25) and ≥45 kg were included in group C (n=20), venous blood and cord venous blood was collected. An ELISA kit was used to evaluate the concentration of adiponectin, leptin, visfatin, and IGF-1, correlations between index-index and index-calf birth weight were analysed. In both cows venous and cord venous blood, adiponectin, leptin, visfatin, and IGF-1 levels were significantly correlated with each other (p<0.01), and levels of these adipokines in venous blood were significantly higher than cord venous blood (p<0.01). Adiponectin, leptin, visfatin, and IGF-1 in venous cord blood were positively correlated with calf birth weights, and significantly correlated with calf birth weights respectively (p<0.01). Our study showed that adiponectin, leptin, and IGF-1 were found in venous blood and cord venous blood, and adiponectin, leptin, and IGF-1 in venous and cord venous blood potentially inter-regulated each other; adiponectin, leptin, and IGF-1 in venous blood were not significantly correlated with calf birth weights, while adiponectin, leptin, visfatin, and IGF-1 in venous cord blood were significantly correlated with calf birth weights, respectively.
Przejdź do artykułu

Abstrakt

A series of Al-5Ti-1B master alloys were obtained via fluoride salt process by holding them between 780°C and 880°C for 10-90 min. The influence of holding temperature and time during preparation on the microstructure and its refining performance were investigated by X-ray diffractometer, optical microscopy and scanning electron microscopy equ ipped with energy dispersive X-ray spectroscopy. The results indicated both the morphology and the distribution of TiB2 and Al3Ti were seriously affected by holding conditions. Inadequate TiB2 particles were generated when holding time was short. However, Fe-containing impurity particles that aggregated along the matrix grain boundaries were found after the prolonged holding time. The refining and microhardness test results revealed that Al -5Ti-1B, the one held at 820°C for 30 min showed the optimum refining efficiency on Al-Cu alloy.
Przejdź do artykułu

Abstrakt

Culture gas atmosphere is one of the most important factors affecting embryo development in vitro. The main objective of this study was to compare the effects of CO concentration on the subsequent pre-implantation developmental capacity of pig embryos in vitro, including embryos obtained via parthenogenesis, in vitro fertilization (IVF), and intracytoplasmic sperm injection (ICSI). Pig embryos were developed in four different CO2 concentrations in air: 3%, 5%, 10%, or 15%. The cleavage rate of pig parthenogenetic, IVF, or ICSI embryos developed in CO2 concen- trations under 5% was the highest. There were no significant differences in the oocyte cleavage rate in ICSI embryos in CO2 concentrations under 3% and 5% (p>0.05). However, as CO2 levels increased (up to 15%) the blastocyst output on day 7, from parthenogenetic, IVF, and ICSI em- bryos, decreased to 0%. These findings demonstrate that CO2 positively affects the developmen- tal capacity of pig embryos. However, high or low CO2 levels do not significantly improve the developmental capacity of pig embryos. The best results were obtained for all of the pig embryos at a 5% CO2 concentration.
Przejdź do artykułu

Ta strona wykorzystuje pliki 'cookies'. Więcej informacji