The paper presents the results of studies on the effect of the AlSi17Cu5 alloy overheating to atemperature of 920°C and modification with phosphorus (CuP10) on the resultingmechanical (HB, Rm, R0.2) and plastic (A5 and Z) properties. It has been shown that, so-called, "timethermal treatment" (TTT) of an alloy in the liquid state, consisting inoverheating the metal to about 250°C above Tliq,holding at this temperature by 30 minutes improvesthe mechanical properties. It has also been found that overheating of alloy above Tliq.enhances the process of modification, resulting in the formation of fine-grain structure. The primary silicon crystals uniformly distributed in the eutectic and characteristics ofthe α(Al) solution supersaturated with alloying elements present in the starting alloy composition (Cu, Fe) provide not only an increase of strength at ambient temperature but also at elevated temperature (250°C).
Paper present a thermal analysis of laser heating and remelting of EN AC-48000 (EN AC-AlSi12CuNiMg) cast alloy used mainly for casting pistons of internal combustion engines. Laser optics were arranged such that the impingement spot size on the material was a circular with beam radius rb changes from 7 to 1500 m. The laser surface remelting was performed under argon flow. The resulting temperature distribution, cooling rate distribution, temperature gradients and the depth of remelting are related to the laser power density and scanning velocity. The formation of microstructure during solidification after laser surface remelting of tested alloy was explained. Laser treatment of alloy tests were perform by changing the three parameters: the power of the laser beam, radius and crystallization rate. The laser surface remelting needs the selection such selection of the parameters, which leads to a significant disintegration of the structure. This method is able to increase surface hardness, for example in layered castings used for pistons in automotive engines.
The cephalopod diet of the gentoo penguin, Pygoscelis papua and the Antarctic fur seal, Arctocephalus gazella was comparatively analyzed at Laurie Island, South Orkney Islands. A total of 125 stomach samples were collected by the water off-loading method from gentoo penguins during the autumns of 1993, 1995 and 1996, and 39 fur seal scats were collected from mid March to April 1988. Cephalopods preyed upon by gentoo penguins were represented by 1974 beaks (1628 lower, 346 upper) which occurred in 50.4% of the samples. Lower beaks identified belonged exclusively to the squid Psychroteuthis glacialis. The mean lower rostral length (LRL) of these beaks was 1.1 mm (range 0.4– 1.8 mm). From the Antarctic fur seal scats 103 beaks (41 lower, 62 upper) were removed from 60.6% of scats which contained prey remains. The cephalopod species identified were Slosarczykovia circumantarctica and P. glacialis which constituted 78.8% and 21.1% in terms of numbers, respectively. The mean lower rostral length for S. circumantarctica was 2.7 mm (range 2.0–3.5 mm), while that of P. glacialis was 1.6 mm (range 1.0–2.5 mm). The foraging behaviour of the two top predators was analyzed and discussed according to the composition and size of their cephalopod prey.