The author investigated traffic flow quality on a new 2+1 long road bypass with an exceptionally high share of heavy vehicles in order to assess rational limits of heavy vehicle shares in traffic flow, dependent on the length of the 2+1 road and the number of passing segments in each direction. This paper presents the results of traffic flow quality analyses through the use of empirical and simulation methods for a single 2+1 road segment with additional passing lanes, as well as for the study of the entire section of the bypass – 2+1 road. Variables include analysis of travel speed distribution, platoon traffic, and amount of passing maneuvers. Results show that large passing demands lead to very high speeds (over 100 km/h) on segments with additional passing lanes. The conclusions include remarks related to the use and operation of 2+1 cross-sections with high shares of heavy vehicles.
The research into the use of less costly modifications of road links and networks, and changes in the service of road surroundings aimed at ensuring an improvement of through traffic performance in suburban areas, and on roads passing through built-up areas as small localities, with application of simulation model, is presented in this paper. From among possible designs, the authors investigated and presented the effectiveness of two, i.e. implementation of an additional multifunctional median lane in the road cross-section, and construction of service roads with different locations of intersections (end or middle of the road section). The analysis is focused on the impact of such changes on traffic performance and road safety. The authors analysed travel speed, delay and share of platoon traffic on a uniform sections of the road for different types of road surroundings service. The study presents the results of analyses of road network before and after modification, and the assessment of: •impact of access points density and level of their use on road traffic performance,•impact of driving through road sections in built-up area on building platoon traffic,•impact of change in the cross-section type on traffic performance.
In the paper methods for conducting Road Safety Inspections (SIs) in Italy and Poland are described and compared. The goal of the study is to improve the quality and efficiency of the safety inspections of road network by using low cost equipment (GPS, Tablet, Camera) and specific software. Particular attention was paid to the need for proper calibration of factors, causing traffic safety hazard associated with road infrastructure. The model developed according to the Italian procedures was adapted to comply with the checklists and evaluation criteria of the Polish guidelines. Overall, a good agreement between the two approaches was identified, however some modification was required to include new safety issues, characteristic for the Polish network for safety inspection of two lane rural roads. To test the applicability about 100 km of regional two lane roads in Poland were inspected with Polish and Italian procedures.